Hello all,
I installed Etch (4.0) on a PowerMac 9600/300 (Old World). The
machine boots fine, but I don't seem to be able to get the X server
to start. The 9600 has an ATI Mach64 PCI video card, and a Sony 17"
monitor connected to it by means of a Mac-VGA adapter. The adapter is
set to a fixed resolution of 1152x870 (but see below).
With the auto-generated Xorg.conf I get this error:
(II) ATI: Candidate "Device" section "ATI Technologies Inc 210888GX
[Mach64 GX]".
(II) ATI: Shared PCI Mach64 in slot 0:13:0 with Block 0 base
0x817FFC00 detected.
(II) ATI: Shared PCI Mach64 in slot 0:13:0 assigned to active
"Device" section "ATI Technologies Inc 210888GX [Mach64 GX]".
(II) Loading sub module "atimisc"
(II) LoadModule: "atimisc"
(II) Loading /usr/lib/xorg/modules/drivers/atimisc_drv.so
(II) Module atimisc: vendor="X.Org Foundation"
compiled for 7.1.1, module version = 6.6.3
Module class: X.Org Video Driver
ABI class: X.Org Video Driver, version 1.0
(II) resource ranges after probing:
[cut -- lots of hex numbers]
(==) ATI(0): Chipset: "ati".
(EE) ATI(0): Driver can't support depth 24
(II) UnloadModule: "ati"
(II) UnloadModule: "atimisc"
(II) Unloading /usr/lib/xorg/modules/drivers/atimisc_drv.so
(EE) Screen(s) found, but none have a usable configuration.
Fatal server error:
no screens found
If I change the DefaultDepth parameter in the Screens section of
Xorg.conf to 16 or 15, I get:
Depht 15|16 cannot be used with this adapter
With DefaultDepth set to 8 (which seems to be the default for this
ATI driver), or commented out altogether, I get:
Linear aperture not available
I have no idea what this last error means. I also tried to change the
settings on the Mac-VGA adapter, but I got the exact same errors. So,
I'm stuck here. Anybody can give me a clue? Or, better yet, a working
Xorg.conf?
Thanks in advance,
Damiano
--
To UNSUBSCRIBE, email to debian-powerpc-REQUEST.TakeThisOut@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster.TakeThisOut@lists.debian.org
Linux